FLORIDATAP REPORTPUBLIC DATA • PLAIN ENGLISHWater News & Answers →

NATIONAL PFAS STUDY · FLORIDA DATA CONTEXT

New PFAS study asks what “below the reporting limit” leaves out

A peer-reviewed analysis of EPA drinking-water records estimates that treating every PFAS result below a laboratory reporting limit as zero can understate national averages. It does not identify a new Florida exceedance or prove that a household’s water is unsafe.

The short answer

“Below the reporting limit” is not the same as a measured zero. But it also is not a measured concentration. The study used statistical models to estimate values that laboratories did not quantify; it did not collect new water samples.

What the researchers analyzed

The study used approximately 1.86 million individual PFAS records from 9,991 community water systems in EPA’s fifth Unregulated Contaminant Monitoring Rule dataset. About 98% of the records examined were below the applicable minimum reporting limit.

Under the researchers’ primary model, a conventional calculation that substitutes zero for those below-limit records captured about 44% of the model-estimated average combined concentration for 25 PFAS detected at least once. That is a national statistical estimate—not a measurement at every utility or tap.

What this means for Florida

Florida public-water systems are included in EPA’s national UCMR 5 data. The finding is relevant when reading a Florida utility result shown as “< MRL,” “not reported above the MRL” or similar wording: the laboratory did not quantify the compound at or above that reporting threshold. The result should not be rewritten as a measured zero.

The study does not publish a new Florida compliance determination, replace provider-specific results or establish that a particular Florida system exceeds a federal limit. EPA separately cautions that UCMR 5 results are monitoring data and do not by themselves determine compliance with PFAS maximum contaminant levels.

How to use a Florida water report

  1. Confirm the provider. Use the utility printed on the current bill, not only the mailing city.
  2. Keep qualifiers attached. A detected value, a below-limit result and an untested compound are different findings.
  3. Do not infer a home result. Utility monitoring does not measure one building’s plumbing or a private well.
  4. Use the right laboratory method. Hardness, TDS and ordinary home screening cannot answer a PFAS question.

Start with the Florida Tap Report provider directory or search EPA’s UCMR 5 Data Finder by state and public water system.

What this article does not claim

This is not a Florida drinking-water alert, a new sample result or a recommendation to buy treatment. The study’s estimates describe uncertainty in national summary calculations; they cannot assign a concentration to an individual below-limit sample.

Sources

Sources checked October 23, 2026. Editorial and corrections standards →